Toshiba Satellite A60 and A65 problems

Let’s talk about problems typical for Toshiba Satellite A60 and A65 notebooks. Do you own one of these laptops? Is it working fine for you?
Here are some typical issues I’ve notices with this model.
1. First of all – overheating
Does your laptop shuts down without any reason when you ran CPU intensive programs? If yes, then most likely it happens because the laptop overheats. It happens because overtime the heatsink gets clogged with dust. A layer of dust collects between the cooling fan and the heat sink (dashed line on the picture) and heat produces by the processor gets trapped inside the laptop. As a result of that, the processor overheats and the laptop shuts down.

There are two different way to clean the heat sink and fan in these models:
– Buy a can of compressed air or find an air compressor and blow off the heat sink through the air intakes on the bottom of the laptop.
– Remove the keyboard and you’ll get an access to the cooling fan. Blow off dust from the fan and the heat sink.
In some cases the laptop overheats because of defective cooling fan. The fan should start working as soon as you power up the laptop. If the fan will not star, most likely it’s bad and must be replaced. You can find a new heat sink cooling fan for Satellite A60 and A65 notebooks by the following part number: V000042110.
2. Defective onboard memory
Here’s another common problem – bad onboard memory. This memory is integrated into the motherboard and if it goes bad you’ll have to replace the entire motherboard.
If your laptop starts with some weird characters or lines of dots on the screen, most likely you have a faulty onboard memory. If you test the laptop with an external monitor, you’ll see the same defective video on the external monitor too. You can test the onboard memory with Memtest86+ utility. Remove any external RAM modules and run the memory test. If the onboard memory fails, you’ll have to replace the motherboard.
The integrated memory module is located close by the memory extension slot, under the foil.

UPDATE: If you have bad memory, you should read this comment.
3. Last but not least – power jack issue.
With Satellite A60 and A65 notebooks this problem is not as common as with Satellite M30X, M35X, A70 and A75, but it’s still a problem. Overtime, the power jack might get loose and the positive pin stops making a good contact with the motherboard anymore. As a result, the laptop switches to the battery power even though the power adapter is still plugged in. Usually you can temporally fix the problem by adjusting the power adapter plug on the back of the laptop, but after some time the problem reappears.
In this case you’ll have to disassemble the laptop, remove the motherboard and resolder the power jack.

Do you experience the same problems or you have another issue with your Satellite A60 or A65 notebook? Please share your experience.

Instructions for replacing laptop power jack yourself

Accessing hard drive using USB enclosure

If for some reason your notebook fails to boot and you need to access data on the hard drive (I assume there is nothing wrong with the hard drive itself), you can use an external USB enclosure. This method is very simple and could be very useful when you need an emergency access to your data on the hard drive.
First of all you’ll have to buy an external USB enclosure for notebook hard drives. These enclosures are inexpensive and usually you can buy them in any local computer store. You also can find a wide variety of external enclosures on the Internet. Make sure to buy a correct one, enclosures for ATA and SATA hard drives are different (the connector inside the case will be different). Usually the enclosure includes the case and the USB cables.

Now remove the hard drive from the laptop. For this example I’m using an ATA hard drive.

Open up the enclosure case and connect the hard drive to the connector inside. After that insert the hard drive into the case.

After everything is assembled, you are ready to connect this device to any working computer (notebook or PC). The enclosure cable usually has two USB connectors on one end, make sure both of them are connected to the computer. You don’t need any external power supply for the enclosure because the hard drive gets power through USB ports. If the computer you are connecting the enclosure to runs Windows 2000 or higher, you will not need any device drivers. As soon as you connect the enclosure to the computer, the external hard drive should be detected and recognized automatically. After that the external hard drive will appear in My Computer and you can access it as any other hard drive in the computer.

If you are getting “Access denied” message when you are trying to access your files on the hard drive, you’ll have to take ownership of a file or folder.
My previous post explains how to connect a notebook hard drive to a desktop PC via IDE hard drive adapter.